Rockwell Hardness Charts for Metals

Choosing a Rockwell Hardness Scale

Below are a few charts that will help you choose the proper set up for your Ames Rockwell portable hardness tester. The charts cover the following :

All information included in this article is found in the Ames Tester Manual. Download it here.

Material to be tested – 

Very hard metals, soft and hard steel, aluminum, brass, and thinner materials can all be tested with our testers.

Brass and aluminum alloys can be handled by using a 1/16 ball

The penetrator that is needed – 

Very hard metals like tungsten carbide, and thin steel needs to be tested using a Diamond penetrator.

Brass and aluminum alloys can be handled by using a 1/16 ball

Brass and aluminum alloys can be handled by using a 1/16 ball

The major load to be applied – 

Your tester is guaranteed to +/- 1 point Rockwell. When using this tester, you must use extreme care to position the pointer exactly on the minor and major load marks.

Lastly, the correct Barrel dial setting – 

The upper line of the barrel’s hardness scales should be exactly aligned beneath the hairline on the magnifier.

Metal hardness chart scale Rockwell Metal Hardness Charts

Here are some commonly used scales on our models.

Frequently Used Rockwell Scales

Please contact us with any questions regarding proper maintenance and set up of our Rockwell testers.

Checking...

Ouch! There was a server error.
Retry »

Sending message...

Rockwell Hardness Charts for Metals

Comments (0)